The top cover provides a housing for the control board, and protection for the electronics and moving parts. Sometimes it can be tricky to remove. We're here to help! Follow the steps below to remove it properly.
- On the back of the unit, unhook the two clips that hold the cover onto the tank below (see photo below). Flex/pull the cover out and away from the softener at these clips.
- There are two similar clips holding the front of the cover on as well. Slide the cover towards you to release these clips. Be careful not to disconnect any wires. It's normal for the plastic cover to produce some noise as it shifts and bends.
Please let us know if this article was helpful by voting below.